Snap Ties are manufactured with integral heads, and Metal or Plastic Form Spreaders. Snap Ties are designed to easily tie lumber forming systems. Snap Ties have a nominal 1" breakback. Each Tie incorporates an anti-turn device in order to properly break after use.Long End, Short End, and Odd End Snap Ties are used with wedge and janh clamp for plywood forming. Available with 1″ x 1″ cones (plastic), washers (metal) and water resistant seal options.
Snap Tie Wedge is a holding device that is fabricated from high strength galvanized steel that is used in a double waler or double strong back snap tie forming application to ensure proper load distribution when installed correctly.
Jahn A Clamp is a holding device fabricated from high strength steel that is used in a single waler snap tie forming application to ensure proper load distribution when installed correctly.
Jahn A Clamps work with Short End Snap Ties, single horizontal walers, or single vertical strongbacks.